Choose the bottom of the enclosure for the first mate. And click on this one over here, which is a multi-mate. And then we're going to mate those to the bottom of the enclosure. And then holding down control I'm going to select and drag out three more. Grab this component here and again I'm just going to zoom in on it and rotate that one around so it's in the right orientation.
Click on Expand That Window and I'm going to spin my enclosure around so I'm looking at the bottom of it. Back in assembly let's go ahead and tile horizontally, and let's go ahead and drag this part in. And it is an older part and a lot of times when you're bringing in files that are downloaded of the Internet or from a vendor it might be a little bit older part, but that's okay. And because it's bringing it in as an imported part just click on no for future works. I'm going to grab this PEM here, which is BSO-6440. And we want to add some PEM hardware to the bottom, to space this board off the inside of the enclosure. We have this board, so we can still slide it up and down. And we have a few dimensions already added. And we have the board placed inside of the enclosure.
